How to resolve a case short on a motherboard
How to resolve a case short on a motherboard
After not posting while building inside the case, I followed the original steps and completed the build outside. I reached the BIOs screen, indicating a successful post, and everything appears to function properly. Now I need to address the case. Is there a problem with the standoffs, screws, or back panel? What should I be checking? The case is a Phantom 240 with an MSI Z97 Gaming 5 motherboard. I believe I installed the standoffs correctly, tightened them well, but didn’t force the motherboard screws in. The back panel has foam, which suggests I had to push firmly against it to fit.
It might be related to a controller problem. You have the choice to employ a fan controller:
http://www.newegg.com/Controller-Panels/...gory/ID-11
I'm sure the standoffs are in the correct place. Should I re-screw them in anyway? Also, is it normal that I had to push a bit to get the motherboard in place against the back panel? Could it be something with the wires?
Here's the case and standoffs if it helps:
http://imgur.com/zaF1lfN
Edit: I only put 9 standoffs in. That's how many the ATX board requires.
Consider removing the module and checking if it boots without the case connections. Alternatively, securing the standoffs with electrical tape might be necessary.
Reinsert the motherboard, attach both 24 and 8 pin power cables, press the case power button, and begin the board. Check if the fan starts to spin.
The I/O panel with foam padding on the motherboard is included. Decide whether to retain or eliminate it.