High temperatures boost performance in 10900kf devices.

Pages (2): 1 2 Next

WikiliZ
Member

196

07-19-2020, 02:24 AM

You've recently replaced your D15 with a new setup and the temperatures remain elevated during Cinebench R23 on multiple cores, reaching up to 100°C. You're currently running it on an ASUS Z490-A.

WikiliZ

07-19-2020, 02:24 AM #1

You've recently replaced your D15 with a new setup and the temperatures remain elevated during Cinebench R23 on multiple cores, reaching up to 100°C. You're currently running it on an ASUS Z490-A.

pierre_man123
Member

07-19-2020, 04:57 AM

Were there previous spikes in heat? Did you make any performance upgrades to the i9-10900KF?

pierre_man123

07-19-2020, 04:57 AM #2

Were there previous spikes in heat? Did you make any performance upgrades to the i9-10900KF?

CHadek
Member

07-19-2020, 07:33 AM

It's set to stock configuration, I haven't performed any overclocking recently—I just assembled this PC yesterday.

CHadek

07-19-2020, 07:33 AM #3

It's set to stock configuration, I haven't performed any overclocking recently—I just assembled this PC yesterday.

jocabq
Junior Member

07-24-2020, 11:44 AM

Are you certain you used the right amount of thermal paste? Asus could have it configured for MCE or an all-core turbo boost to raise the processor’s speed across all cores. Do you have sufficient airflow into the case? You can test this by taking off the side panel and checking if temperatures dropped.

jocabq

07-24-2020, 11:44 AM #4

GalaxyPv
Junior Member

07-24-2020, 05:39 PM

You think you used enough paste, the application looked decent. Removing the side panel didn’t reduce the max to 100°C, so I’ll look into the MCE next.

GalaxyPv

07-24-2020, 05:39 PM #5

You think you used enough paste, the application looked decent. Removing the side panel didn’t reduce the max to 100°C, so I’ll look into the MCE next.

MasterCed
Member

07-26-2020, 01:28 AM

No, I didn't remove the film from the bottom of the CPU block.

MasterCed

07-26-2020, 01:28 AM #6

No, I didn't remove the film from the bottom of the CPU block.

JustRhune
Member

199

07-26-2020, 08:32 AM

The cooler featured just a plastic shield over the plate

JustRhune

07-26-2020, 08:32 AM #7

The cooler featured just a plastic shield over the plate

Monganboys
Junior Member

07-26-2020, 03:13 PM

It seems the automatic mode was already disabled.

Monganboys

07-26-2020, 03:13 PM #8

It seems the automatic mode was already disabled.

twentyonechloe
Member

235

08-01-2020, 03:36 PM

I didn't use any thermal paste myself. Could you clarify which one you're asking about?

twentyonechloe

08-01-2020, 03:36 PM #9

I didn't use any thermal paste myself. Could you clarify which one you're asking about?

JamesHond7
Posting Freak

838

08-02-2020, 08:19 AM

#10

The typical NT-H1 included with the cooler

JamesHond7

08-02-2020, 08:19 AM #10

The typical NT-H1 included with the cooler

Pages (2): 1 2 Next