Help with building a Ryzen 8500G system using ASRock B650M-HDV M.2 or B650M Pro RS
Help with building a Ryzen 8500G system using ASRock B650M-HDV M.2 or B650M Pro RS
ASRock B650M-HDV M.2 or B650M Pro RS. My requirements are clear: no RGB header, no WiFi, no dedicated GPU, 16GB or 32GB DDR5 RAM, 1TB SSD, power supply and fan needed, budget-friendly, simple setup, located in Canada, used for full stack software development without games, running Linux only. What is the total system power usage?
What is the total budget cost?
I usually suggest opting for a slightly higher CPU with an 8600G, as the performance from the GPU is significantly better and it has double the units for a much lower price compared to the 8500G.
The recommended RAM speed is around 6400MHz.
I chose the B650 Pro RS because of the BIOS flashback feature, which is crucial for updating the BIOS on the motherboard since B650 chipsets require an update to support the G series 8000.
I selected two 1TB drives as a safety measure and also opted for PCIe Gen 4.0, which is more affordable than Gen 5 but still meets your needs.
The power supply seems a bit too large since adding a GPU or upgrading would require more power at 650W rather than lower wattages like 550 or 450W.
Thank you for your idea! Based on my budget, I have selected the most cost-effective components, such as choosing 8500G instead of 8600G, and so on. I don’t intend to upgrade much in the coming years.
I enjoy checking the overall system power usage before deciding on a power supply.
Both motherboards offer ASRock BIOS Flashback and Auto Driver Installer, which you can find here:
https://www.asrock.com/mb/AMD/B650M-HDVM...cification
https://www.asrock.com/mb/AMD/B650M Pro RS/index.asp#Specification
which ever is more affordable
https://ca.pcpartpicker.com/list/dvbryg
for more drive suggestions, consider this heatsink
https://www.amazon.ca/Heatsink-Alum...-3-spons&spc=1
updated with power supply that should work well. a 550w unit leaves plenty of room since the system will draw around 220w. honestly, it will be cheaper with a PSU, as it does more harm than good. i usually make sure to have about double what i’m drawing because PSUs lose efficiency over time, just like batteries. and the closer you get to the maximum wattage of a PSU, the faster it wears out.
example: my system draws at max 350w. i use a 650w PSU. i don’t expect this PSU to fail after another 4 years. i’ve had it for 3.
It's impossible to guarantee perfect accuracy with all components, even identical ones. Wattage requirements or part selection estimates may vary. 184 watts adds roughly 40 more for better reliability. I wouldn't recommend using a PSU under 450w (like Seasonic or TheMaltake) unless you're using a smart thermal design. Corsair