F5F Stay Refreshed Hardware Desktop Have trouble starting your PC after upgrading RAM and entering BIOS.

Have trouble starting your PC after upgrading RAM and entering BIOS.

Have trouble starting your PC after upgrading RAM and entering BIOS.

T
TheCraftom
Junior Member
Find
36
10-05-2023, 03:31 PM
#1
Hi, I decided to upgrade my ram today after my pc was struggling playing games as it was using up all the memory. I installed the ram like normal and turned the PC on where it booted into the bios. I activated xmp profile and saved and exited. The fans were still spinning however the monitor detected no output and the keyboard and mouse were not on. So I looked to reddit and found some who said to reset the cmos. I did that and the pc booted in to the bios once again and a screen popped up confirming the reset of the bios. I activated xmp again and booted it up but once again blank screen with the fans spinning but this time there was an output detected and the keyboard and mouse were on. I did this a few times turning on and off the PC but it gave the same outcome. It is a Prebuilt from Medion and its been 7 hours of me trying to solve it and researching but I can't figure it out. I saw that someone said that some prebuilts boot of uefi and me resetting the board removed the profiles. Also I don't know if this is an issue but my boot drive a 512gb ssd doesn't show up under boot sequence like it used to (last image where it shows intel octane next to windows boot manager) Please help. I've stressed too much today.
Reply
Reply
T
TheCraftom
10-05-2023, 03:31 PM #1

Hi, I decided to upgrade my ram today after my pc was struggling playing games as it was using up all the memory. I installed the ram like normal and turned the PC on where it booted into the bios. I activated xmp profile and saved and exited. The fans were still spinning however the monitor detected no output and the keyboard and mouse were not on. So I looked to reddit and found some who said to reset the cmos. I did that and the pc booted in to the bios once again and a screen popped up confirming the reset of the bios. I activated xmp again and booted it up but once again blank screen with the fans spinning but this time there was an output detected and the keyboard and mouse were on. I did this a few times turning on and off the PC but it gave the same outcome. It is a Prebuilt from Medion and its been 7 hours of me trying to solve it and researching but I can't figure it out. I saw that someone said that some prebuilts boot of uefi and me resetting the board removed the profiles. Also I don't know if this is an issue but my boot drive a 512gb ssd doesn't show up under boot sequence like it used to (last image where it shows intel octane next to windows boot manager) Please help. I've stressed too much today.

Reply
Reply