F5F Stay Refreshed Hardware Desktop Getting Started Assistance

Getting Started Assistance

Getting Started Assistance

M
Matke04
Posting Freak
825
07-02-2021, 02:48 PM
#1
Finished setting up my first system with an i3 10100 10th gen Gigabyte Z590 Aorus Ultra (LGA 1200) WD 1 TB Wd Blue NVMe drive. Capacity is 32 GB, 3200MHz Vengeance RAM, and everything in the BIOS works fine. XMP USB install boots correctly and runs smoothly. After installing Windows 11 Pro via USB, I received a warning: "System does not meet requirements." The hardware looks sufficient for a direct installation of Windows 11. I can still install Windows 10 via USB and update registry settings if needed, but prefer a clean direct install. Should I adjust BIOS settings to make the USB recognition valid?
M
Matke04
07-02-2021, 02:48 PM #1

Finished setting up my first system with an i3 10100 10th gen Gigabyte Z590 Aorus Ultra (LGA 1200) WD 1 TB Wd Blue NVMe drive. Capacity is 32 GB, 3200MHz Vengeance RAM, and everything in the BIOS works fine. XMP USB install boots correctly and runs smoothly. After installing Windows 11 Pro via USB, I received a warning: "System does not meet requirements." The hardware looks sufficient for a direct installation of Windows 11. I can still install Windows 10 via USB and update registry settings if needed, but prefer a clean direct install. Should I adjust BIOS settings to make the USB recognition valid?

M
mccoop03
Posting Freak
910
07-02-2021, 04:17 PM
#2
Check if your CSM configuration is accurate. Xmp doesn't always work well; revert it to the default and test acceptance. Are you employing GPT alongside an SSD?
M
mccoop03
07-02-2021, 04:17 PM #2

Check if your CSM configuration is accurate. Xmp doesn't always work well; revert it to the default and test acceptance. Are you employing GPT alongside an SSD?

B
bishopboys68
Posting Freak
899
07-10-2021, 08:47 AM
#3
You're using NTFS + GPT with a WD 1TB NVMe SSD. I'm not sure if that's the best setup, but it works. For the CSM settings, you might want to check the manufacturer's recommendations or consult the official documentation for your specific drive model. This is your first build, so feel free to ask more questions! Thanks for reaching out, SansVarnic.
B
bishopboys68
07-10-2021, 08:47 AM #3

You're using NTFS + GPT with a WD 1TB NVMe SSD. I'm not sure if that's the best setup, but it works. For the CSM settings, you might want to check the manufacturer's recommendations or consult the official documentation for your specific drive model. This is your first build, so feel free to ask more questions! Thanks for reaching out, SansVarnic.