Get guidance on linking the Thermalright Peerless Assassin 120 SE ARGB fan.
Get guidance on linking the Thermalright Peerless Assassin 120 SE ARGB fan.
At the base of your board on the right side, there are four 4-pin connectors labeled sys_fan1 through sys_fan4_pump. These are the points where you can attach the case fans. The fourth pin is for powering a pump in an AIO or water cooling system, though the manual notes it can also function as a standard fan connection.
You're really impressive, that's for sure. I've got three supporters at the bottom and two extra ones on the side. Not sure if they should be connected together yet, but once I figure it out and have any questions, I'll try to get them back here. You're right about the fans—thinking of reaching out to Thermalright to clarify the RGB details and request a replacement black splitter since mine isn't working.
I'm still trying to understand how to set up the cooler, but I think you've got the basics covered. I hope this helps get your PC running. You don't need both CPU fans on the cooler—just use the one that fits. If a wire is stuck, stick with the available fan and figure out how to remove it later or replace it if necessary. Keep in mind, connect the fans correctly to the motherboard: one for power, one for ground, and ensure the ground pin matches the color code shown in the diagram.
You should note that using just one fan on the cooler might not perform well, and you might end up needing two fans depending on your CPU to avoid thermal throttling. While this could get you running temporarily, it isn't necessarily the optimal choice for the future.
Yes, this involves linking the power supply unit. One end should connect to the motherboard while the other goes into the PSU. Make sure you keep them separate to avoid confusion.