games frequently stop working after adding extra memory (2x 8gb t-force 3000mhz delta rgb)

F5F Stay Refreshed Hardware Desktop games frequently stop working after adding extra memory (2x 8gb t-force 3000mhz delta rgb)

Pages (2): Previous 1 2

ItzMaark
Member

110

09-28-2019, 12:19 PM

#11

Technically speaking, the 2600's design, RAM capacity and BIOS settings must all align with those specifications. (Apologies for the confusion, as Summit Ridge can handle up to 3200mhz depending on the RAM model.) Even if the board doesn't officially support it, it should function. It's simply seen as being overclocked past certain limits within the BIOS.

ItzMaark

09-28-2019, 12:19 PM #11

Actionize
Junior Member

09-28-2019, 01:40 PM

#12

Hey, I get it. I adjusted it to 2666 but it’s still showing up as 2400. Not sure what’s going on.

Actionize

09-28-2019, 01:40 PM #12

Hey, I get it. I adjusted it to 2666 but it’s still showing up as 2400. Not sure what’s going on.

xIsoxGaming
Member

211

10-20-2019, 10:02 AM

#13

Was das ein Problem, das Sie bemerkten, als es bei 3000 läuft? 2400 ist der Standardwert, den der BIOS verwendet, unabhängig von der RAM-Geschwindigkeit. Du kannst die 3000-MHz-RAM nicht einfach so installieren und sie würde immer 3000 hz laufen. Es muss so eingestellt sein.

xIsoxGaming

10-20-2019, 10:02 AM #13

Maluwtf
Junior Member

10-20-2019, 03:14 PM

#14

Open BIOS settings, turn on XMP profile, adjust frequency to 3200 Hz and set DRAM voltage to 1.36V.

Maluwtf

10-20-2019, 03:14 PM #14

Open BIOS settings, turn on XMP profile, adjust frequency to 3200 Hz and set DRAM voltage to 1.36V.

techiseasy
Senior Member

688

10-27-2019, 01:02 PM

#15

I enable XMP mode, adjust the voltage, confirm RAM speed is set to 3000MHz, and decide whether to reinstall the CMOS battery or restart the setup.

techiseasy

10-27-2019, 01:02 PM #15

I enable XMP mode, adjust the voltage, confirm RAM speed is set to 3000MHz, and decide whether to reinstall the CMOS battery or restart the setup.

0ZeroGaming0
Member

152

11-02-2019, 12:31 AM

#16

I enable XMP mode, adjust the voltage, confirm RAM speed is set to 3000MHz, and decide whether to reinstall the CMOS battery or restart the setup.

0ZeroGaming0

11-02-2019, 12:31 AM #16

I enable XMP mode, adjust the voltage, confirm RAM speed is set to 3000MHz, and decide whether to reinstall the CMOS battery or restart the setup.

Sunahh
Posting Freak

863

11-02-2019, 05:45 AM

#17

It could make sense to turn everything off, remove the data, and then reinsert it, beginning fresh.

Sunahh

11-02-2019, 05:45 AM #17

It could make sense to turn everything off, remove the data, and then reinsert it, beginning fresh.

NerdTrooper
Member

11-02-2019, 09:50 AM

#18

Thank you for your assistance.

NerdTrooper

11-02-2019, 09:50 AM #18

Thank you for your assistance.

Pages (2): Previous 1 2