FX6300 first time OC.
FX6300 first time OC.
Hey everyone, I'm still getting familiar with overclocking, so I wanted to check in and make sure I don't cause any issues. I upgraded my FX6300 to 4.3 Ghz at 1.32V, and everything looks good. The power-saving settings are turned off in BIOS, even for HPC. My RAM is set to the stock Extreme Profile with 1866 MHz (channel interleaving enabled, Auto Ranking Settings, standard timing). Can I keep this configuration with these changes?
Also, I have a few components: FX6300 at 4.3 Ghz with Cooler Master HyperEvo 212, Gigabyte GA 970a-UD3P motherboard, Corsair V. Red Pro 1866 MHz RAM (2x8), MSI R9 380 4G running at +1.7% clock speed with a 0% power limit, a Kingston HyperX Savage 480GB SSD (500/550) and a 1TB Toshiba HDD, a Chieftec Force Series CPS 650W 85+ PSU, plus some USB peripherals like a Zowie mouse, Razer Deathstalker Chroma, and a HyperX CloudII headset. A USB stick Wi-Fi adapter is also installed. Prime95 is running while I write this, and so far everything seems normal. Should I try pushing it further for stability, or stick with this setup? Also, what might be the signs of problems in the future if I play games or use the PC beyond freezing or shutting down? I just want to know if this configuration could cause issues later. Thanks for your help, and sorry for the grammar—I'm not entirely native English!
The screenshot reference provided is for the current stage of the process.
We must understand the temperatures we observe and the approach used for stress testing.
My process involves increasing the clock speed by 200-400mhz above the standard setting. I execute an x264 stress test for half an hour. If the system remains stable, I proceed; otherwise, I adjust voltage until stability is achieved.
This cycle repeats until the processor reaches its limits, temperatures become excessive, or I reach a satisfactory level.
Subsequently, I run x264 for 5 to 8 hours based on the overclock intensity. I also perform 10 to 100 Intel burn tests (functioning well on AMD as well) to verify temperature stability.
Once everything passes, I conduct a bootable memtest usb to assess RAM health—typically 1 to 2 passes are sufficient, or I allow it to run overnight.
I prefer the x264 stress test for its reliability, though Prime95 works adequately for AMD chips. Intel processors tend to overheat more under Prime95 due to unique instruction sets.
I added a screenshot link where your temperatures are visible after about 2.5 hours. Thanks for your reply!
CountMike reports the temperature is acceptable, but warns that the voltage is near its maximum allowed level. Suggests using AMD Overdrive for better accuracy.
CountMike shared his findings about the temperature being acceptable, but noted the voltage (VIN1) reaches its maximum safe level. He suggested using AMD Overdrive for better accuracy and mentioned checking the BIOS settings, where he saw similar readings of 1.5V on another board. He asked if that was typical.
It should be Vin0 in AOD to check. 1.5v is the best voltage for FX processors; I can reach up to 1.478v at full load of FX 6350 at 4.82GHz.
The correct setting should be Vin0 in AOD to check. The highest recommended voltage for FX processors is 1.5v, and I can achieve up to 1.478v at full load of the FX 6350 at 4.82GHz. It's unclear if I should adjust it manually in BIOS or not. Another user shared that they had stable performance at 4.4GHz with a CPU Vcore of 1.32 and a VID voltage of 1.5, similar to mine, but they achieved better temperatures around 2-3°C.