Frequent BSOD issues, application failures, system reboots following RAM replacement and testing.
Frequent BSOD issues, application failures, system reboots following RAM replacement and testing.
However, if it matches the exact same version you already own, everything should be fine. Otherwise, 2x8GB kits might be overpriced and you should keep just one full kit on your PC (either 2x16GB or 4x8GB). Without that, you risk running into crashes like these (smh, RAM tech T.T)?
I updated my reply with some more information, please refresh. And yes, if the two kits use the same parts then they have a much greater chance of working. If it's on the QVL and validated with four sticks then it should work. There is some silicon lottery with the CPU involved as well, depending on the speed and timings you want. My experience is probably skewed like I said, but I personally prefer getting a new kit. And usually opting for two sticks over four when possible. Not related, but the new CPUs REALLY struggle with four sticks and DDR5. The officially supported max speed on 7000 series AMD with four sticks is 3600MT/s, basically DDR4 speeds. Four sticks is just much harder on the memory controller. EDIT: From AMD
Always opt for a 2x configuration. Memory controllers struggle more with four sticks. Also, keep in mind that purchasing the same kit at different times can cause issues.
I understand, it sounds like you're considering a bigger 2-piece kit for your RAM upgrade. If you decide to return the old units, selling them at a loss on the used market makes sense. It might not be the easiest plan, but it seems like the best option right now. Thanks for reaching out and getting advice!
It's really confusing considering the real effects of various RAM versions, especially since it might be hard to spot this before purchasing...
Before reaching the final decision, I’d try the new RAM separately first. If it fails when used alone, it might be defective. I should have mentioned that sooner, but my post was more meant to inform and support. Memory testers often overlook RAM problems, so it’s better to use it under normal conditions instead.
I ran some tests using memtest86+ on a USB drive. I checked both the new and old RAM sticks individually, and there were no errors. I also installed the RAM in the same setup as when I got the new sticks and ran an overnight test for 10 hours with 7 passes, getting zero errors. I expected any faulty RAM to show up in the tests, especially during that long run.
I’ve essentially stopped using RAM testers since they consistently show clean results even when the RAM is actually bad.