Find a way to connect across the narrow path using Wi-Fi or another method.
Find a way to connect across the narrow path using Wi-Fi or another method.
I attempted to connect via WiFi but the connection is extremely slow, only providing 10mbit. I previously had a standard cat5e cable that worked fine, but it stopped functioning recently. Installing a new one will be challenging since I’m not sure how to do it. The old setup was managed by my ISP seven years ago, and I also need to maintain strong security.
When lightning strikes a cable, it's considered normal. Installing a cable is straightforward—simply fasten the new cable to the existing one at one end and pull the old cable out from the other. Once positioned, attach the required head to the cable and that's complete.
Obtain a direct connection configuration similar to the TP-Link CPE210. Ensure devices can communicate with each other. Choose a suitable bandwidth based on your needs. For outdoor use, select a UV and moisture-resistant cable. Standard cat cables won’t work outdoors—they degrade over time and can’t handle long distances. You’ll likely need steel cable for the cat cable to be properly secured.
Jaslion advised tying the end of the existing cable with a string to a matching new cable. Pull the old cable from the wall about 5 meters ahead, cut it at the connectors, and if they’re intact, simply attach it to the new one. Should any connector be damaged, replace it or swap with another patch cable you own. If you intend not to replace the cable and are switching to repeater mode, set it to 802.11n with repeating and 40MHz (for fewer networks), or for 5GHz use 802.11ac at 80MHz (assuming no older devices). Ensure you have at least two or three antennas at each end. This setup works well if your router supports Wi-Fi 5 or 5GHz. One antenna should handle communication between routers, while another connects your devices inside the house—preventing speed drops. As Dujith mentioned, make sure the repeater gets a strong signal, free from obstructions, and consider re-cabling if possible. Another useful method is using Powerline Adapters if your home and the building share the same electrical phase. This can boost performance. Another good suggestion from Slayerking92.
Configure a PtP wireless bridge operating on 5GHz. Although a 5-meter distance works well for shielded Ethernet between buildings, the roadside segment remains uncertain—whether underground or exposed. You can’t safeguard all gear against a direct lightning strike, but without physical cabling between the two structures, damage to both sides becomes impossible. A wireless PtP bridge maintains connectivity via wireless links only. Since the station or AP must be installed outside the buildings, mounting it on the exterior wall (beneath roof cover) is advised, ensuring clear line-of-sight between devices, and employing Ethernet surge protectors.