Failed to connect to NAS following router installation.
Failed to connect to NAS following router installation.
I've been relying on the Zyxel NAS326 for many years. The internet service changed the router to a newer model, and now I can't connect. It looks like DHCP isn't assigning an IP address, yet the admin panel shows packets being sent and received on the port my NAS uses. The green LED near the LAN port isn't lighting up. Could this indicate a hardware problem with my NAS?
This sounds like you may just wanna reapply a static ip that is not the same. Highly doubt it's a hardware issue sounds like stupid dhcp
appears to be static with a fresh router setup. switch the IP from your previous range into the network card using the config. test connectivity by pinging each address and verify responses. if access works, log into your browser, enable DHCP, or assign a fixed IP in the new subnet.