Extreme heat using manual voltage control
Extreme heat using manual voltage control
I achieved 4.7ghz all cores at 1.264V, and it worked with IBT using the high preset. Should I try Prime? Also, I noticed something unusual: hwmonitor and cpu-z reported a vcore of 1.264, while in the BIOS it was set to 1.275. Is there a reason for this discrepancy?
Prime 95, Small FFT, AVXs Off, focuses more on thermal stability rather than voltage stability. The stress it imposes is significant, yet it behaves differently from benchmarks like Cinebench R20 or Asus Realbench(V 2.56), which are designed for evaluating Vcore stability. Vdroop and Load Line Calibration are handled at the hardware level through Vroop, which cannot be disabled.
Was das wirklich nur eine einzelne Durchführung war oder hast du einen 'unendlichen Loop' eingeleitet?
Infinite Loop: Öffne die Datei, klicke darauf und wähle Präferenzen. Unter Minimum Test Duration gib eine völlig unmögliche Zahl ein, wie 9999999999999, und es wird automatisch auf das Maximum gesetzt. Führe es dann etwa eine Stunde lang durch – je länger, desto besser.
Das sollte funktionieren. Kein Nutzer sollte höher als die Standard-Einstellungen für mittlere LLC verwenden, es sei denn, du verwendest LN2 oder die VRMs sind flüssiggekühlt.
It was only a single run; I plan to try it with an infinite loop, thank you for your assistance. I'm also considering removing the CPU.