Excessively boosted graphics settings negatively impacted performance.
Excessively boosted graphics settings negatively impacted performance.
You were experimenting with your Athlon X2 4600+ system and the integrated graphics settings, but they're causing issues. You're looking for instructions on how to reset it.
Clear CMOS Configuration
Disable the computer and detach the power cord from the socket.
Take off the protective cover.
Find the 2-pin password connector (PSWD) on the board.
Remove the 2-pin jumper.
Identify the 2-pin CMOS jumper (RTCRST) on the board.
Transfer the jumper from the password position to the CMOS slot.
Connect AC power and allow ten seconds for the CMOS to reset.
Return the jumper to the password position.
Reinstall the cover.
Plug in your computer and devices, then switch them on.
Clear CMOS Configuration
Disable the BIOS settings stored in the CMOS chip.
Power off the machine and unplug the power cord from the outlet.
Take off the protective cover over the device.
Find the two-pin password connector (PSWD) on the board.
Remove the two-pin jumper from the password connector.
Identify the two-pin CMOS jumper (RTCRST) on the board.
Transfer the two-pin jumper from the password connector to the CMOS position.
Restore AC power and allow ten seconds for the CMOS to reset.
Return the two-pin jumper to its original location.
Reinstall the cover and connect your computer and peripherals to outlets, then power them on.
On the board, the clear CMOS pins are located at the bottom middle (near the lowest PCI slot). Turn off the computer, unplug it, and press the power button to discharge any residual energy in the capacitor. Use a screwdriver to briefly connect those two pins together. Reinsert the computer and attempt to restart it. Check if it powers on.