Ethernet surge protectors paired with ground wires
Ethernet surge protectors paired with ground wires
Hi, I experienced a router issue caused by current entering through your Cat6 cables. You're using one of these cables to prevent this again. How can you connect it properly with the building's grounding system—do you have a small plug or a screw-in option? Also, are there any ways to inspect the wiring yourself to ensure it's genuine, since brand-name products aren't available locally?
Examine the screw at the center of your outlet covers. It should fit into the metal casing of the socket, correct? The ground wire is also attached to that casing. If not, you can swap in a socket with a grounded housing, which will also ground the central screw. Once that’s done, you can install the cable as shown in the image on the right. Alternatively, consider a device like the one on the left; search for “ESD Ground Plug,” though these are typically for banana plugs. Source: https://electronics.stackexchange.com/qu...lectricity
Thank you for your response. From my research, it looks like linking the leads to the ground jack is sufficient. I didn’t find a pre-made plug in my area and had to create my own solution. It’s impressive how free software and a $120 3D printer can help. Solution – Top of the Plug Bottom Side of the Plug, with the bottom two plugs being 3D printed.