Ethernet connection isn't working properly.
Ethernet connection isn't working properly.
This was one of the oddest problems I've encountered during my tech experiments. My Ethernet setup isn't functioning properly. A few months ago I set it up using standard cables and followed these steps: router → wall hole → outdoor male-to-male cable → female-to-female wall plate → another cable → switch → PC. I used pre-made cables since I didn’t have a crimping tool, and I was concerned about making mistakes. I’ve inspected every connection, even removing the wall plate to check for damage. Everything seems secure and undamaged. The issue appears to be with the outdoor cable, as both the router and the switch show no signal. I’m hoping there’s something simple I missed, especially since I’d rather avoid another setup. Thanks everyone!
Sorry, this sounds like a bad cable to me. Things you can check, 1) does your switch see your pc? (i.e., if you ping from your pc out do you see activity on that port of the switch?) 2) if 1) is okay then check at the wall plate - that is plug another device in there and do the same ping test to see if you get activity on the port. 3) if 2) is okay then go out unplug the outside cable and pug in a short cable and another short cable to the back side of the f/f wall plate if that doesn't work it's the wall plate, if it does then it's the m/m cable - probably.
Yes, I have a laptop equipped with an Ethernet port for detailed inspection of the connection.
I'll review everything you mentioned. It seems the computer isn't recognizing it as connected.
Are you operating within the internet connection restrictions?
Yes, connecting to something other than localhost (even your actual IP address) should show traffic on the switch port you're using and on your computer's port. If not, it might mean there are more issues than the cables—try plugging a physical Ethernet device into the switch to check if it lights up. It could indicate a problem with your computer's port.
It could just mean one of your three cables isn't working properly.
Thanks to everyone for their support. I reviewed everything and found the wall plate was the problem. Appreciate all the assistance!
There seems to be an issue with the connection inside the wall plate.