F5F Stay Refreshed Software Operating Systems Error occurred when accessing a non-paged memory region during a BSOD.

Error occurred when accessing a non-paged memory region during a BSOD.

Error occurred when accessing a non-paged memory region during a BSOD.

1
101Magic
Junior Member
48
08-10-2016, 10:03 AM
#1
You're dealing with a dual-boot setup where both Windows 10 installations are running on separate M.2 drives. The issue seems to stem from the Nvidia driver update affecting only your personal drive, causing boot problems on the work drive. Since the personal drive is functioning normally, it's likely the update impacted the work drive's configuration or access. To resolve this, you may need to reinstall the driver on the work drive or check for conflicting system settings.
1
101Magic
08-10-2016, 10:03 AM #1

You're dealing with a dual-boot setup where both Windows 10 installations are running on separate M.2 drives. The issue seems to stem from the Nvidia driver update affecting only your personal drive, causing boot problems on the work drive. Since the personal drive is functioning normally, it's likely the update impacted the work drive's configuration or access. To resolve this, you may need to reinstall the driver on the work drive or check for conflicting system settings.

C
CapivaraManca
Member
152
08-26-2016, 03:31 PM
#2
The system needed more memory to keep functioning, but the page wasn’t found and Windows couldn’t proceed, causing it to crash. This is the situation you’re describing. The NVIDIA drivers likely weren’t the cause. In your experience, always opt for a custom installation and perform a clean install of new drivers. This approach works well for me, especially since my build was in 2017.
C
CapivaraManca
08-26-2016, 03:31 PM #2

The system needed more memory to keep functioning, but the page wasn’t found and Windows couldn’t proceed, causing it to crash. This is the situation you’re describing. The NVIDIA drivers likely weren’t the cause. In your experience, always opt for a custom installation and perform a clean install of new drivers. This approach works well for me, especially since my build was in 2017.