F5F Stay Refreshed Hardware Desktop Disable XMP output to prevent any display output.

Disable XMP output to prevent any display output.

Disable XMP output to prevent any display output.

S
Sebluigi
Senior Member
727
11-22-2022, 10:07 PM
#1
I just installed a new setup: Asus ROG Strix B660-F with the latest BIOS, Kingston Fury 2x8 DDR5 5600/13700K. The system starts up and works fine, but I didn’t set XMP initially, so RAM is at 4000 MHz. After changing BIOS to enable XMP, no display appears and the CMOS shows a reset. I cleared the CMOS and the screen came back. Anyone know what’s going on? Besides manually boosting RAM speed, are there other suggestions?
S
Sebluigi
11-22-2022, 10:07 PM #1

I just installed a new setup: Asus ROG Strix B660-F with the latest BIOS, Kingston Fury 2x8 DDR5 5600/13700K. The system starts up and works fine, but I didn’t set XMP initially, so RAM is at 4000 MHz. After changing BIOS to enable XMP, no display appears and the CMOS shows a reset. I cleared the CMOS and the screen came back. Anyone know what’s going on? Besides manually boosting RAM speed, are there other suggestions?

T
thadiahunta
Member
60
11-24-2022, 03:57 AM
#2
on my previous board there were two distinct XMP configurations; one functioned while the other didn’t. If you possess two XMP profiles, consider using the slower one. Otherwise, verify whether the RAM meets the mobile compatibility requirements.
T
thadiahunta
11-24-2022, 03:57 AM #2

on my previous board there were two distinct XMP configurations; one functioned while the other didn’t. If you possess two XMP profiles, consider using the slower one. Otherwise, verify whether the RAM meets the mobile compatibility requirements.

O
ObiJuanKenobe
Junior Member
41
11-30-2022, 09:09 AM
#3
I believe I've watched a clip from der8auer where he faced the same issue using the same board. It appeared in a video about overclocking a 12400, and he manually configured the RAM to match the XMP settings (both speed and primaries), which resolved the problem perfectly.
O
ObiJuanKenobe
11-30-2022, 09:09 AM #3

I believe I've watched a clip from der8auer where he faced the same issue using the same board. It appeared in a video about overclocking a 12400, and he manually configured the RAM to match the XMP settings (both speed and primaries), which resolved the problem perfectly.