Disable VGA audio output
Disable VGA audio output
Hi there! I know this can be confusing, especially if you're new to PC setup. Your Asus Rog Strix Z690-F is working fine, but those beeps when you power on can be both useful and bothersome. There might be a way to silence or adjust them depending on your BIOS settings. Could you check the manufacturer's documentation or look into BIOS options for noise control? Let me know if you'd like more guidance! Thank you for reaching out.
Did you set up a POST code speaker? (It’s often affected by your front panel wiring) Consumer boards typically don’t include it as a built-in function, which is the main reason I’m seeing this...
You should pay attention to the different sounds like a long one, two short ones, or three long ones. Whatever they are, the best way to stop them is to figure out what each sound means and then check what those sounds indicate. Based on their meaning, you’ll need to address the issue they represent. Solving the problem is the only solution to prevent the beeping. It’s similar to that little red light that lights up when you start up—it usually signals a CPU problem. Instead of LEDs, it’s just beeps. Good luck!
It seems uncertain if the software is present. Three days ago your PC was delivered and upon first boot it triggered a beep.
It's just the standard power-up sound. Certain BIOS settings let you disable it. If unavailable, simply remove the power source. This isn't related to VGA identification. It's likely the final check before the startup tone plays.