Did the overclocking damage your CPU?
Did the overclocking damage your CPU?
Hello! I'm just starting out with overclocking. I've only ever done a small amount of GPU tuning before and then returned to the standard settings. Recently, I tried to boost my CPU's speed. Unfortunately, my system didn't start properly—though it powers on fine. Here’s what I have set up: Windows 10 & EndeavourOS MSI B450 GAMING PLUS MAX, latest BIOS, AMD Ryzen 3600 processor, Noctua NH-U12S 2x8GB Corsair Vengeance LPX (with XMP 3600 MHz), a 1TB PNY SSD from Corsair RM750 powered by a 750W PSU. I followed both guides at once, switching between them as instructed. I ran a full memory check and everything seemed normal. Initially, I used the auto OC feature on the motherboard, then manually adjusted it to 4.4GHz after skipping some checks. After that, I did a Prime95 test, but the temps spiked to 100-110°C, which was concerning. I let it run for about 30 seconds before stopping it completely. After restarting, I lowered the frequency back to 4.2 and tried another Prime95 run, which stopped immediately due to overheating. A 3DMark CPU-only test also failed to finish properly. At this point, I’m worried my CPU might be damaged. Do you think I should give up or keep trying? Also, I only have a spare PSU (Seasonic S12...) for troubleshooting. What are your thoughts? Could it be that I damaged it? Thanks!
Disconnect the CMOS, then it should work again. Unplug the device. Locate the CMOS battery. Take it out and let it sit for a while. Reinsert it and restart the system.
Thanks for your messages! I chose to remove the battery since I’m unsure how to short the pins. I also don’t recognize a jumper cap—I only have time for the final episode of TechNews right now. I’ll reattach the battery later.
Gently contact the two pins, labeled in the guide, together with a metal object such as a screwdriver. Wait a moment and the task is complete. Additionally, there is no risk of electric shock involved.
I was planning to add a similar remark! Screwdriver is always there to assist, haha.