Device signals activity upon LG C1 activation
Device signals activity upon LG C1 activation
Hello, I'm dealing with a problem that's been bothering me for a while. My setup includes a workspace with three monitors and a drawing tablet, plus a 'relax' area featuring an OLED TV. Everything is connected to one PC, which I use for freelance work during irregular hours. The challenge is switching smoothly between these spaces. With four displays, I need to run both my 1080Ti and 3080 graphics cards. However, using the LG TV has caused some issues—when I power it on with the remote, the computer stutters, and the screens flicker for about half a minute before sometimes stabilizing for minutes. This also occurs after turning off the PC if I haven’t used it for ten minutes. It can happen randomly, depending on whether the TV is connected or not, or even when it’s on but I connect an HDMI 2.1 cable to the GPU. I’ve updated drivers and experimented with G-SYNC/HDR settings, tried different ports and cables, including high-quality optical HDMI 2.1 from KabelDirekt for the TV and StarTech VESA-certified cables for the monitors. Once the flickering stops, everything works fine except for the disruption when switching between work and leisure. This affects my ability to take breaks or maintain focus when returning. Any advice would be greatly appreciated! - CJ Displays: 3 x Samsung LU32H850 4k Monitors 1 x Huion KAMVAS 22 Plus 1 x LG C1 OLED PC: Windows 10 CPU - Ryzen 5950x GPU 1 - EVGA 3080 XC3 GPU 2 - Aurobindo 1080Ti Xtreme MB - Aurobindo x570s Master RAM - 128GB Corsair Vengeance LPX DDR4 3600MHz C18
It's completely normal. Windows detects a new display connection but can't sync properly until the TV is fully powered on. This causes blinking as it attempts to connect, which continues until the TV is ready.