F5F Stay Refreshed Hardware Desktop CPU temps too high ?

CPU temps too high ?

CPU temps too high ?

Pages (2): Previous 1 2
O
OwlCornz
Member
65
03-29-2022, 10:20 PM
#11
You might want to perform this straightforward check; adjust each fan to full speed and allow the CPU to idle for about ten minutes. Observe the temperature drop and determine if it’s normal—this could indicate your fan curves require tuning.
O
OwlCornz
03-29-2022, 10:20 PM #11

You might want to perform this straightforward check; adjust each fan to full speed and allow the CPU to idle for about ten minutes. Observe the temperature drop and determine if it’s normal—this could indicate your fan curves require tuning.

D
DeGekkeTijger
Member
110
03-30-2022, 12:08 AM
#12
*insert that racist kid gif here* lol
And Noo!!! Haven't you been following the news? There is a common failure point of X3D processors literally burning up and it's ASRock. Nobody knows why at this point. Processors and board are fake dead (revivable with a custom unreleased BIOS), others have literal burn marks on the board and processor and are dead, dead, dead.
Just humor me and set a custom VO Curve and repaste. See what your temps are after.
D
DeGekkeTijger
03-30-2022, 12:08 AM #12

*insert that racist kid gif here* lol
And Noo!!! Haven't you been following the news? There is a common failure point of X3D processors literally burning up and it's ASRock. Nobody knows why at this point. Processors and board are fake dead (revivable with a custom unreleased BIOS), others have literal burn marks on the board and processor and are dead, dead, dead.
Just humor me and set a custom VO Curve and repaste. See what your temps are after.

C
ChEwYsTeWiE123
Junior Member
41
03-30-2022, 10:25 AM
#13
-Brought from the prior cpu(7820X) via the Eisbaer Aurora 360(Phanteks T30-120s)
-EXPO is active
-The cores are adjusted to adaptive mode (previously all cores were used)
It appears to run at around 40C
/shrug
C
ChEwYsTeWiE123
03-30-2022, 10:25 AM #13

-Brought from the prior cpu(7820X) via the Eisbaer Aurora 360(Phanteks T30-120s)
-EXPO is active
-The cores are adjusted to adaptive mode (previously all cores were used)
It appears to run at around 40C
/shrug

Pages (2): Previous 1 2