CPU overheating due to RAM issues.
CPU overheating due to RAM issues.
Hello, your RAM overclocking attempt didn't succeed. After rebooting and restarting the PC, you encountered a black screen with no output. The motherboard display indicated a missing CPU. You're using a Ryzen 5 3600, and you've already tried removing the battery without success. It's possible the issue could damage your CPU, so proceed with caution. Consider reinstalling the BIOS or checking for other hardware faults.
I experienced the same issue, but skipping the CMOS battery resolved it. Have you allowed a minimum of 5 minutes between reinserting the battery?
I increased the clock speed using the BIOS settings. I tested various parameters but avoided extreme overclocking to prevent damage. Resetting the BIOS and letting the PC fail to boot is recommended. If you suspect a faulty CPU, remove it from the socket, inspect for signs of heat or burn, and check manually.
I adjusted it via the BIOS during timing changes. I was using 1.37 V and running Patriot Viper 3600 CL17. It seems to be loading Hynix CDJD or similar. Only a single RAM stick is detected.
Reset BIOS and CMOS fully, then test each stick individually to confirm recognition. If one fails on all slots, relocate it to another position. If stick 1 works on one slot but not the others, it may be damaged—consider installing both and performing a memory test.
I tested the RAM and everything worked fine. Loose timings are the problem now. I need at least 16t, but I'm unsure how to adjust them properly. Did you try using a DRAM calculator? Any suggestions would be helpful. Otherwise, I might ask my friend to check it on his bike.
These instructions are about boosting your RAM speed rather than strict rules. From my experience with Ryzen, persistence is key. Follow the suggestions but feel free to increase voltage if needed. The RAM you chose would have been discarded sooner if it hadn’t been available, making it more valuable that way. Overclocking chances might be limited beyond the built-in XMP setting.
Ryzen demands precise memory settings. Adjusting AM4 memory can be tricky. Using a DRAM calculator is fine, but keep in mind your CPU might not handle that frequency. At 3600Mhz it's quite demanding for a Ryzen. It's better to aim for incremental improvements. Also, the RAM voltage seems low—consider testing with 1.5V for RAM and 1.2V for SOC, though you may need to adjust timings or lower the frequency to 3200Mhz.
I receive 3600Mhz on tCL16 TRCDWR17... It works stably at 1.365V with a 1.1V supply. Is there a specific critical voltage? The system remains cold, and I can't locate the uClock settings. I'm using an MSI X570 gaming edge—knowing terrible VRM specs but accidentally damaging my B450, which was owned by a friend. Are there any BIOS restrictions or am I missing something?