Connection via cable Attachment using cable
Connection via cable Attachment using cable
Hey, I see you're having trouble with the cable connections. For the hub, you'll need to plug the 4-pin unlabeled cable into one port and the 3-pin connector into another. The RGB fans also have a 3-pin connector—you can connect both to a single cable for simplicity. Just make sure each port matches the correct pin configuration. Let me know if you need more details!
Which case and CPU cooler are you employing? Did you intend to link the reset switch button to the fan/RGB PCB switch header?
I'm setting up a cooler with the Master H500, using an Argon cooler model Ag620BK.
Also intended to link the reset switch button with the fan/RGB PCB switch header?
You linked the wires to the board, or they were there from the start. From the frame, it seems the connections were made, and possibly the reset switch was also attached as a main power control for the lights.
From the manual, the 4-pin port connects to the motherboard or the fan/RGB board based on your setup choice (I’d connect it to the CPU fan header). It features two female terminals for the fans. The 3-pin part serves the RGB fans, with each fan having two connectors. One end plugs into the RGB header—either the fan/RGB controller or a motherboard header—and the other fan links sequentially to the first one.
Edited February 26, 2023 by Godlygamer23
The RGB hub or fan hub you're referring to has three cables: a 4-pin connector, a 3-pin connector, and a power cable (which you've already connected). My main concern is figuring out the best placement for them.