Connecting Router to WAN Network
Connecting Router to WAN Network
You can connect directly to the Linksys EA6350 router using its built-in web interface or SSH. By accessing the router via a browser or command line, you can manage settings, forward ports, and interact with its devices without relying solely on the WAN connection.
You should confirm my suggestions as they might not always be accurate but could still be useful. The second router needs its own IP address since both cannot share the same one. Most Linksys models offer a web interface—open a browser and enter the IP you assigned to the second router to access settings. This applies mainly for wired connections. Linking other devices should be simpler if they’re on the same network range. For example, if your main router is 192.168.1.1 and the second is 192.168.1.2, using a similar IP like 192.168.2.1 will still allow communication with some adjustments. Basic usage won’t recognize devices unless you configure the network to detect them automatically. You’ll need this setup already in place for it to function properly. If you try via Wi-Fi, additional steps are required. I haven’t used this method recently, but I read that keeping the SSID similar can help extend signal strength. Keep in mind this is general advice—verify it suits your situation. Good luck!
When devices are separated, they function not just as an access point but as a completely separate network. The purpose behind placing them in a different LAN isn’t just accidental—it depends on your setup goals. Usually, the simplest solution is to disable DHCP on the second router and connect it via a LAN port to the main network; then it behaves like an access point. However, if you need to reach its UI, assigning a static IP on the main network beforehand is necessary.