Configure WireGuard using Edgerouter ER-X as a client with Mullvad as the server.

F5F Stay Refreshed Power Users Networks Configure WireGuard using Edgerouter ER-X as a client with Mullvad as the server.

Configure WireGuard using Edgerouter ER-X as a client with Mullvad as the server.

Configure WireGuard using Edgerouter ER-X as a client with Mullvad as the server.

C

CzarnyJakup
Member

224

07-01-2016, 08:21 AM

#1

I can include my config file link... Here it is. My Wireguard setup for edgerouter ER-X. (I chose to skip VLAN first to test the configuration.) Hello, I installed WireGuard on my ER-X and have a VLAN for that purpose. My goal is to direct traffic from the VLAN to the WireGuard interface. I set it up with two networks: one for 192.168.1.1 and another for the VLAN at 192.168.100.1. The VLAN runs on Eth2 with an Access Point attached. In short, all devices connected to the AP should be routed through WireGuard. What CLI commands should I use? I’m not very comfortable with the command line but can follow clear instructions. Most guides assume the ER-X is a server, not a client. Could anyone help me with this? Thanks a lot!

C

CzarnyJakup

07-01-2016, 08:21 AM #1

I can include my config file link... Here it is. My Wireguard setup for edgerouter ER-X. (I chose to skip VLAN first to test the configuration.) Hello, I installed WireGuard on my ER-X and have a VLAN for that purpose. My goal is to direct traffic from the VLAN to the WireGuard interface. I set it up with two networks: one for 192.168.1.1 and another for the VLAN at 192.168.100.1. The VLAN runs on Eth2 with an Access Point attached. In short, all devices connected to the AP should be routed through WireGuard. What CLI commands should I use? I’m not very comfortable with the command line but can follow clear instructions. Most guides assume the ER-X is a server, not a client. Could anyone help me with this? Thanks a lot!