Configuration for extending or setting up a network repeater.
Configuration for extending or setting up a network repeater.
I checked how to handle network repeaters properly. For your setup—ISP Router, TP Link switch, then wireless devices—I want to know when I should repeat my copper signal to keep speeds high. Do you need a router or switch to act as a repeater, or is special gear required? Thanks!
It varies based on the distances involved. Because the router connects only to a 100Mbps switch, you wouldn’t require any extra cables for your network. Cat6 supports gigabit speeds up to around 100 meters.
Certainly! To confirm, repeating the signal is necessary only after traveling 100 meters with a CAT6 connection.
I believe my timing is off. If that's the case, what options exist to retry the transmission?
Consider running Ethernet if you need a stable connection. WiFi repeaters, boosters, or extenders operate at half-duplex and aren't ideal for speed or reliability unless you must use them. If forced to choose, go with the basic setup: Modem/gateway → Primary router → Wireless access point or gigabit switch (location A) | V Wireless access point or gigabit switch (location B).
If I had to cover more than 100 meters, I’d switch directly to fiber optics or media converters. I wouldn’t waste time on signal boosters or repeaters. However, others mentioned the typical limit is around 100 meters for Gigabit over Cat5e/Cat6. Exceeding that can cause signal loss and packet errors.