CL22 listed under CL16 description?

Pages (2): 1 2 Next

Lostjose
Junior Member

02-16-2016, 07:00 PM

I purchased this memory kit for my PC, but it's labeled CL16. Recently, I noticed it appears in CPU-Z. Could it be because it's currently at CL16 at base frequency? Using the XMP profile seems to increase its latency. If that's the case, what does a higher frequency mean? Probably, absolute latency remains constant even though higher frequencies raise the access time slightly. You might be mistaken.

Lostjose

02-16-2016, 07:00 PM #1

LuizaDiAngelo
Junior Member

03-08-2016, 09:12 PM

Display the SPD section featuring the selected memory module.

LuizaDiAngelo

03-08-2016, 09:12 PM #2

Display the SPD section featuring the selected memory module.

kizoutau
Junior Member

03-08-2016, 09:23 PM

These appear correct. Would you like an explanation for the differences between the two tabs?

kizoutau

03-08-2016, 09:23 PM #3

These appear correct. Would you like an explanation for the differences between the two tabs?

SkyInsane
Senior Member

718

03-16-2016, 01:21 AM

The module indicates its capabilities, while the memory section shows the active configuration. Your BIOS setup should be configured with XMP enabled. Please specify your processor model and motherboard type.

SkyInsane

03-16-2016, 01:21 AM #4

jerrydog01
Senior Member

703

03-17-2016, 07:07 PM

It seems XMP wasn’t used; instead, the 3200MHz JEDEC standard applies, requiring a CL22 minimum.

jerrydog01

03-17-2016, 07:07 PM #5

It seems XMP wasn’t used; instead, the 3200MHz JEDEC standard applies, requiring a CL22 minimum.

UberSean
Member

03-17-2016, 08:46 PM

I’ll look into the BIOS settings, but I think I just set XMP or DOCP. (I usually refer to it as XMP...)

UberSean

03-17-2016, 08:46 PM #6

I’ll look into the BIOS settings, but I think I just set XMP or DOCP. (I usually refer to it as XMP...)

Reazly
Junior Member

03-18-2016, 10:01 PM

Yes, you can configure the memory to run at 3200 MHz instead of using DOCP settings. This would allow it to utilize the JEDEC timing parameters.

Reazly

03-18-2016, 10:01 PM #7

Yes, you can configure the memory to run at 3200 MHz instead of using DOCP settings. This would allow it to utilize the JEDEC timing parameters.

Synonikun
Junior Member

03-19-2016, 03:05 AM

This could be possible, though I'm not convinced. I'll inform you once I can restart.

Synonikun

03-19-2016, 03:05 AM #8

This could be possible, though I'm not convinced. I'll inform you once I can restart.

Evolution88
Member

216

03-19-2016, 04:50 AM

Here are the screenshots of each slot. You mentioned having 32GB but only 16GB of G.Skill kit—this suggests a possible mismatch in latency modules.

Evolution88

03-19-2016, 04:50 AM #9

Here are the screenshots of each slot. You mentioned having 32GB but only 16GB of G.Skill kit—this suggests a possible mismatch in latency modules.

PKM1
Junior Member

03-19-2016, 09:13 PM

#10

Sure

PKM1

03-19-2016, 09:13 PM #10

Sure

Pages (2): 1 2 Next