Check if running four sticks of this RAM at 6000 MHz is compatible with your system.
Check if running four sticks of this RAM at 6000 MHz is compatible with your system.
Currently I have two 16GB sticks, totaling 32GB. I’m thinking about adding two more identical sticks and using them in the unused slots, running them at 6000 MHz. Your system info is available here: https://pcpartpicker.com/list/hBw3fy. If the graphics card isn’t a factor, it should be swapped for a 4080 or 5080 model once the 50-series models are released.
Sure, that's understandable. 6000 CL 36 moves a bit slowly at times.
Yes, having two DDR5 RAM sticks meets the requirement, even if the total capacity isn't specified.
The problem with XMP/EXPO ram is that it is never 100% guaranteed to work. 6000 is considered the sweet spot for Zen 4, but there's always some chance you get unlucky with your combination of CPU/mobo/ram. I'm running Corsair Vengeance EXPO 6000C30 2x32GB on a 7800X3D fine.
Honestly, it's 6000 CL34. Way beyond CL 30. Based on what I've done before, I believe 4 sticks should be manageable. If it doesn't work out, you can always slow down and reduce latency.
It varies depending on the setup—CPU, motherboard, BIOS, RAM, etc. I tested it and it functioned fine in its case. Some systems struggle more. You're taking a risk, and the claim about 6000cl36 being slow might be exaggerated. Especially with X3D chips, performance isn't significantly affected.
The key point to grasp when moving from 2 sticks to 4, even with newer CPUs, is that you're increasing the load on the memory controller. Running "out of the box" or EXPO settings without adjustments becomes more challenging, especially with four sticks installed. Each kit has slight differences, much like CPU binning in terms of performance ranges—but not as extreme as before. Some kits support higher speeds, while others don’t, depending on the CPU’s memory controller and the motherboard. I recently upgraded memory modules myself, and while it was necessary for certain applications (like Stable Diffusion Flux needing more RAM), it didn’t guarantee top performance. Running 4 sticks isn’t guaranteed; it mostly hinges on whether your CPU has a reliable memory controller. The situation can vary by brand. I’m still satisfied with my recent purchase, though I went overboard. I’ve seen 60-76GB of RAM in use, which explains why the 2x16GB kit struggled before. Now I have a 2x48GB unit, and I’m considering running both at once to test performance. The 2x48GB is expensive (CL32 6400MHz), but it’s working fine at CL30 6200MHz with tighter timings. If you’re unsure, try the larger configuration and see how it performs. Keep in mind that some kits are pricier and may not run smoothly under stress. I’m still learning, but I can guide you if you need help. G.Skill is generally a top choice for balancing speed and cost, though quality varies. Good luck!