Attempted to improve my GPU, but the system is no longer booting.
Attempted to improve my GPU, but the system is no longer booting.
I used QFlash+ to install the new BIOS successfully (followed the correct steps with the right lights and turned it off at the end), then re-seated the CPU, reinstalled the cooler, and installed one stick of 16gb RAM in the second slot from the left. I reset the CMOS by removing the battery and holding the start button for 30 seconds. After waiting 5 minutes, I put the battery back in and tried to boot the computer again, but the same issue occurred.
I plan to return the board for an RMA since it's still under warranty.
Before starting, did you switch off the power supply and check for any lights?
The issue was resolved through a motherboard RMA. Initially, I couldn't determine if the CPU was the cause, so I contacted Gigabyte who sent it back without any explanation. After receiving the repaired board, everything functioned correctly. I tried removing my 1060 and swapping it for a 4070, but the motherboard still worked fine. It seems either replacing the GPU caused damage or a physical issue occurred during the swap.