ASUS X570 Tuf and Patriot Ram DOCP problems
ASUS X570 Tuf and Patriot Ram DOCP problems
To run that kit at 3800C14 you're going to need closer to 1.5V on DRAM and to run tight timings you'll most certainly need 1.5V. I'll post some tight timings your kit will likely run, but again you'll likely need at least 1.5V (which is fine for b-die). Be sure to set FCLK in BIOS. Be sure to set enough SOC voltage. Start at 1.1V and see if it can be reduced. Instability presents as USB dropouts and crashing etc. I need 1.1V on SOC. For CLDO VDDG voltages -- your board should set those fine, but if it doesn't then use 1.05V and for CLDO VDDP 1.0V. You'll wanna try 1T with GDM enabled. Your kit may be able to run 1T with GDM disabled so try it. I've seen some that can and some that can't.
Additionally, this site is useful: https://www.overclock.net/forum/13-amd-g...bench.html