Asus Tuf Gaming X570 Plus (Wi-fi)

F5F Stay Refreshed Hardware Desktop Asus Tuf Gaming X570 Plus (Wi-fi) - no ads

Asus Tuf Gaming X570 Plus (Wi-fi) - no ads

02-12-2019, 05:59 AM

Hello everyone, I'm setting up my first PC and using an Asus Tuf Gaming X570 Plus with Wi-Fi. I just started booting and ran into some problems. At first, the RGB lights on the GPU, RAM, CPU cooler, and motherboard lit up, fans spun, but the VGA and BOOT LEDs stayed on and the build didn’t save. After taking out my GPU and trying again (only the white LED appeared), I put it back in. Now the board cycles through all the LEDs and then turns them off after a few seconds—still no graphics output via HDMI or DisplayPort. I’ve tried removing RAM, checking connections, and everything seems fine. Any advice on what to do next? For reference, here’s my build: https://pcpartpicker.com/list/MdVJwh

Darthdread1

02-12-2019, 05:59 AM #1

mrfire918
Junior Member

02-12-2019, 11:14 AM

Consider using a different PCIe slot. If you have an alternative card, switch to another GPU in the system.

mrfire918

02-12-2019, 11:14 AM #2

Consider using a different PCIe slot. If you have an alternative card, switch to another GPU in the system.

Hooded_Master
Member

187

02-12-2019, 11:33 AM

Tried another PCI-e port but faced the same problem. No other graphics card available for testing. Also observed the GPU fans aren’t turning, though the RGB stays active. Unclear if this indicates an issue, since I’m aware my GPU turns off fans when it’s warm.

Hooded_Master

02-12-2019, 11:33 AM #3

DaFluffy123
Junior Member

02-13-2019, 01:40 PM

It looks like a possible DOA card. I’d check if you have a relative or acquaintance you can swap with to test compatibility.

DaFluffy123

02-13-2019, 01:40 PM #4

It looks like a possible DOA card. I’d check if you have a relative or acquaintance you can swap with to test compatibility.

IGraffie
Member

02-13-2019, 02:19 PM

I did a bit more research and found the issue was switching the monitor to use the motherboard's input instead of the graphics card's. Everything seems to be functioning now.

IGraffie

02-13-2019, 02:19 PM #5

I did a bit more research and found the issue was switching the monitor to use the motherboard's input instead of the graphics card's. Everything seems to be functioning now.