ASUS Hyper M.2 issue? Check for errors, reset settings, or contact support.
ASUS Hyper M.2 issue? Check for errors, reset settings, or contact support.
I possess a Hyper M.2 x16 Gen 4 card paired with an i7-9700K processor, alongside two Samsung 970 Evo Plus 500 GB SSDs. It was placed in the first PCIe X16 slot as specified in the guide. The Hyper M.2 is active in BIOS, yet only one 970 Evo Plus appears in the disk management tool. Where is the remaining drive?
Consider relocating the SSDs to other slots. It seems you can only fit them in slots 1, 3, and 4 on this board.
Could you clarify your question? The instructions don't mention this detail.
Did it work? I'm curious Intel only lets you split the x16 on their mainstream platform to x8x4x4 instead of x4x4x4x4 on some other platforms. There is also a compatibility guide somewhere that lits all the boards it works in and how many drives you cna use.
The second 970 Evo Plus appeared in the disk management tool. However, could you clarify how to configure them for RAID 0? When checking CrystalDiskMark, they still display performance as one 970 Evo Plus.
I would utilize storage areas there. Looking for storage options in Windows lets you configure an array.
The speeds aren't combined because the testing method doesn't sum them. Using Simple mode in CrystalDiskMark avoids this behavior. What’s happening?
Adjust the column width to 2 for optimal speed. Unfortunately, this should still be handled via PowerShell. Remove the existing virtual disk, then apply new-virtualdisk with columnsize 2 and configure the remaining settings.