Adjusting the DVAM frequency
Adjusting the DVAM frequency
It's typical for devices to operate at 2666 MHz when XMP isn't active. Speeds above that generally need XMP enabled or a manual overclock. The highest JEDEC standard is 3200 MHz @ CL20, but most units run at 2666 MHz and require XMP or overclocking to achieve the advertised performance.
Enable the XMP profile to modify the clock to 3200 and fine-tune timing and voltage settings according to the programmed profile. Adjusting the clock to 3200 will push the module beyond its normal specifications, but it should function properly if everything is correctly configured.
Increasing clocks alone usually isn't enough. Normal DDR4 needs about 1.2V, but overclocking pushes it to around 1.35V and might require timing adjustments. Using an XMP profile becomes simpler if the RAM supports it.
It's strange since after setting up both RAM sticks, adjusting the frequency, but I reset everything, my computer keeps shutting down unexpectedly?
Are you using a set of two matching sticks, or did you combine one stick with an existing one on your PC?
You might have received a faulty unit, so perform some diagnostic checks to identify any issues. Clearing the CMOS or resetting the BIOS settings could help. When using the auto configuration, RAM should automatically switch to plug-and-play mode without problems. If this doesn’t work, the device is likely defective—consider testing each module separately or returning it for replacement if needed.
Restart your BIOS to restore default configurations. Activate XMP and it should function properly. Keep all automatic settings active except the XMP profile, which will handle the necessary adjustments for the kit to operate at 3200. Did it work before you made these changes?