Adjusting performance on a Ryzen 3 3100 processor

11-14-2019, 01:39 PM

I'm just starting out with overclocking and I'm not sure what the best settings are. I used Ryzen Master to adjust the overclock and everything worked fine until things got tricky. I set my speed to 4.125 GHz and the voltage to 1.225. I'm confused about what's happening but it didn't crash at all! I tried Cenibench and FurMark to stress test my CPU, but it still didn't crash. I really need some help—I don't understand what's going on.

YourMCAdmin

11-14-2019, 01:39 PM #1

Angelgq
Junior Member

11-18-2019, 07:59 AM

While operating under stress, the temperature reaches 79°C and drops to 52°C without load.

Angelgq

11-18-2019, 07:59 AM #2

While operating under stress, the temperature reaches 79°C and drops to 52°C without load.

TheFrenchKiwi
Junior Member

11-18-2019, 03:34 PM

Core clock set at 4.125GHz with a voltage of 1.225V works fine—no crashes detected. That indicates stable operation. Consider raising the voltage and observe the results.

TheFrenchKiwi

11-18-2019, 03:34 PM #3

Core clock set at 4.125GHz with a voltage of 1.225V works fine—no crashes detected. That indicates stable operation. Consider raising the voltage and observe the results.

jonathan16p
Junior Member

11-18-2019, 10:38 PM

Temperature rises above 87 at around 1.3 volts

jonathan16p

11-18-2019, 10:38 PM #4

Temperature rises above 87 at around 1.3 volts

OMGitzbrent
Member

155

11-18-2019, 11:50 PM

cinebench isn't enough for testing, furmark causes GPU strain. Try blender, OCCT small/large data sets, or p95 small FFTs—p95 runs are much hotter than expected.

OMGitzbrent

11-18-2019, 11:50 PM #5

cinebench isn't enough for testing, furmark causes GPU strain. Try blender, OCCT small/large data sets, or p95 small FFTs—p95 runs are much hotter than expected.

Fritztech
Member

218

11-20-2019, 04:19 PM

The CPU has a burner located in the fur mark area.

Fritztech

11-20-2019, 04:19 PM #6

The CPU has a burner located in the fur mark area.

Quackz_
Member

11-21-2019, 12:11 AM

I continued the process. Achieved 4.225 ghz across all cores at 1.225 volts with no fluctuations!!!!

Quackz_

11-21-2019, 12:11 AM #7

I continued the process. Achieved 4.225 ghz across all cores at 1.225 volts with no fluctuations!!!!

ApeBarrel
Member

214

11-28-2019, 05:11 PM

I've never seen this before... 5 years old feature (I've tried overclocking twice). I didn't hear about it until now. The reason I mentioned cinebench isn't enough is because it can handle 3850mhz at 1v, but p95, occt, blender and tougher tests stop above 3700mhz.

ApeBarrel

11-28-2019, 05:11 PM #8