F5F Stay Refreshed Hardware Desktop Activating the resizing bar within the BIOS settings again.

Activating the resizing bar within the BIOS settings again.

Activating the resizing bar within the BIOS settings again.

F
ForceField_ON
Junior Member
36
06-07-2022, 07:57 AM
#1
Hi, I see you're trying to turn on rebar on your ArcA770. Every time you try from the BIOS it gets rejected. You mentioned disabling CSM and enabling higher than 4G decoding. Your specs look solid—R7 5700X, 32GB RAM, 3600Hz, 1HP SSD, and a boot drive with 500GB. Make sure rebar is properly installed and not corrupted. Also verify the system settings in BIOS are correct for rebar mode. If issues persist, check for any pending updates or firmware fixes.
F
ForceField_ON
06-07-2022, 07:57 AM #1

Hi, I see you're trying to turn on rebar on your ArcA770. Every time you try from the BIOS it gets rejected. You mentioned disabling CSM and enabling higher than 4G decoding. Your specs look solid—R7 5700X, 32GB RAM, 3600Hz, 1HP SSD, and a boot drive with 500GB. Make sure rebar is properly installed and not corrupted. Also verify the system settings in BIOS are correct for rebar mode. If issues persist, check for any pending updates or firmware fixes.

T
tensaimicky
Member
214
06-07-2022, 09:15 AM
#2
Is the latest BIOS already set up? Otherwise, consider trying it.
T
tensaimicky
06-07-2022, 09:15 AM #2

Is the latest BIOS already set up? Otherwise, consider trying it.

S
Syndic8or
Junior Member
11
06-15-2022, 05:59 AM
#3
Yes
S
Syndic8or
06-15-2022, 05:59 AM #3

Yes

P
Pyracel
Junior Member
25
06-28-2022, 10:56 PM
#4
Only bios are recommended. Rebar enabled or above 4G encoding. CSM seems irrelevant unless you're using an older AM4 board. (b450)
P
Pyracel
06-28-2022, 10:56 PM #4

Only bios are recommended. Rebar enabled or above 4G encoding. CSM seems irrelevant unless you're using an older AM4 board. (b450)