A server board has been moved and the system is not starting.

F5F Stay Refreshed Hardware Desktop A server board has been moved and the system is not starting.

A server board has been moved and the system is not starting.

A server board has been moved and the system is not starting.

W

WildCandy
Senior Member

675

07-17-2016, 09:02 PM

#1

You're experiencing an issue with your Z9PE-D16/2L server board where the system reports the error code 'd5'. This indicates a problem related to the Legacy Option ROM, which is necessary for certain older operating systems. According to ASUS documentation, this means there isn't enough space allocated for that ROM. You've already optimized your RAM usage by removing most of it except one stick, yet the error persists. Since no hardware changes have been made, you might want to check the available space on the drive or consider expanding it if possible. Consulting ASUS support or checking the motherboard documentation could also provide further clarity.

W

WildCandy

07-17-2016, 09:02 PM #1

You're experiencing an issue with your Z9PE-D16/2L server board where the system reports the error code 'd5'. This indicates a problem related to the Legacy Option ROM, which is necessary for certain older operating systems. According to ASUS documentation, this means there isn't enough space allocated for that ROM. You've already optimized your RAM usage by removing most of it except one stick, yet the error persists. Since no hardware changes have been made, you might want to check the available space on the drive or consider expanding it if possible. Consulting ASUS support or checking the motherboard documentation could also provide further clarity.

E

entech
Member

210

07-18-2016, 12:04 AM

#2

Clear the system and reset the BIOS before trying to start it.

E

entech

07-18-2016, 12:04 AM #2

Clear the system and reset the BIOS before trying to start it.

C

courtenay12
Junior Member

11

07-18-2016, 02:50 AM

#3

I tried to skip that path... it’s less than 2 inches of walnut with epoxy.

C

courtenay12

07-18-2016, 02:50 AM #3

I tried to skip that path... it’s less than 2 inches of walnut with epoxy.

A

Aeronees
Member

75

07-18-2016, 10:21 AM

#4

ultimately broke everything down. Replaced the nic, and it cleared through. Fixed several issues I could resolve, and everything functioned properly.

A

Aeronees

07-18-2016, 10:21 AM #4

ultimately broke everything down. Replaced the nic, and it cleared through. Fixed several issues I could resolve, and everything functioned properly.