A few of my memories are displaying at 1066Mhz.

F5F Stay Refreshed Hardware Desktop A few of my memories are displaying at 1066Mhz.

193

09-22-2020, 02:28 AM

Hey! Just set up a new MOBO, CPU, and PSU. Installed 4x8GB Corsair Vengeance 3200Mhz RAM and booted up. After checking HWINFO, slots 0 & 3 run at 1066Mhz, 1&2 at 1333Mhz. I replaced those with new DIMMs but still can't get a boot. XMP is enabled but fails to start, and the system says the issue is with the DRAM. Got any suggestions? Specs: MSI X570 Gaming Plus, Ryzen 7 5800X, RTX 2080TI, 4x8GB Corsair Vengeance LPX, RM580X PSU.

truji8tarifa

09-22-2020, 02:28 AM #1

DinoSubz
Member

09-23-2020, 01:37 AM

I'm facing the exact same problem too, though I believe my RAM failed because I was on a long session.

DinoSubz

09-23-2020, 01:37 AM #2

I'm facing the exact same problem too, though I believe my RAM failed because I was on a long session.

Artur630
Member

168

09-23-2020, 01:56 AM

DDR stands for Double Data Rate. It doubles the speeds shown by HWINFO to display accurate rates.

Artur630

09-23-2020, 01:56 AM #3

DDR stands for Double Data Rate. It doubles the speeds shown by HWINFO to display accurate rates.

PDGA54190
Junior Member

09-23-2020, 06:32 AM

Consider updating the BIOS since your system is running a Ryzen 5000 but the BIOS version is outdated from July 2020. The flash tool reports no media detected, even though you've prepared the files correctly on a Fat32 partition and inserted them into the Flash Bios slot.

PDGA54190

09-23-2020, 06:32 AM #4