A computer locks up unexpectedly due to excessive RAM and CPU overclocking.
A computer locks up unexpectedly due to excessive RAM and CPU overclocking.
couldn't share your specs directly but you can provide a link.
high load line calibration, EIST turned off.
vcore set to 1.3v after that.
once functioning, reduce vcore until failure, then increase by two clicks.
Start by testing vCore at 1.26, observe the results. Followed your advice and disabled C State 3, which resolved the problem. Attempted stress-testing with Aida 64 but it reported hardware errors. Identified the issue as unstable RAM according to software. Restored it to 1600Mhz with optimized timings, and ran for an hour without errors. Could consider L0stChild's suggestions if instability persists. Interested in experimenting with LLC settings. Appreciate the assistance!
All right, everything seems fine and you're doing great, ahead of schedule. CStates definitely handle it, I usually focus on DRAM, with the MC voltage adjusted accordingly for the rest of the parameters.