3-pin RGB connector with a bent pin design
3-pin RGB connector with a bent pin design
Hello everyone, I need to replace the RGB cable during a move. One of the pins is bent at about 30 degrees. Is this similar to a CPU pin where you can simply straighten it? What tool would be best for this? I've attached a photo. Thanks!
You can simply return it using a tweezer or similar tool. It shouldn't break because it hasn't been bent more than once or twice. No problems expected.
It seems the item needs careful adjustment. Be gentle; it can only bend a limited number of times before breaking. Have you attempted using a connector and inserting just one side (only one pin in place) while gently bending it back? If that fails, I’m sure you’ve used basic tools like a small screwdriver or even a plastic spudger to avoid scratching. It shouldn’t be difficult.