F5F Stay Refreshed Hardware Desktop 12V 4-pin ATX port assistance

12V 4-pin ATX port assistance

12V 4-pin ATX port assistance

R
rikkert3123
Member
53
10-06-2022, 05:17 PM
#1
Hello, I don't have exact specs for the connector length, but you can try bending the cables as much as possible without breaking them. Physical testing would give the most accurate result, though it's not currently feasible.
R
rikkert3123
10-06-2022, 05:17 PM #1

Hello, I don't have exact specs for the connector length, but you can try bending the cables as much as possible without breaking them. Physical testing would give the most accurate result, though it's not currently feasible.

H
heyitsjackson
Member
170
10-06-2022, 08:02 PM
#2
Another spot where you can buy them, I believe? Updated March 7, 2025 by thrasher_565
H
heyitsjackson
10-06-2022, 08:02 PM #2

Another spot where you can buy them, I believe? Updated March 7, 2025 by thrasher_565

W
WindOfFlamez
Member
244
10-07-2022, 07:01 PM
#3
Hello, this connector should help with your issue. Unfortunately, I can't locate them locally and overseas shipping will be delayed. You have 22 milimeters from the female side. Please check the measurement from the connector tip to where the cables bend to see if it fits. Also, knowing the length of the mating part inside the female end would be useful.
W
WindOfFlamez
10-07-2022, 07:01 PM #3

Hello, this connector should help with your issue. Unfortunately, I can't locate them locally and overseas shipping will be delayed. You have 22 milimeters from the female side. Please check the measurement from the connector tip to where the cables bend to see if it fits. Also, knowing the length of the mating part inside the female end would be useful.

N
nicjohn2000
Member
149
10-08-2022, 09:13 PM
#4
It varies by cable; some are stiffer while others are more bendy. The outer plastic section of the male connector when connected to the female side is usually around 1cm.
N
nicjohn2000
10-08-2022, 09:13 PM #4

It varies by cable; some are stiffer while others are more bendy. The outer plastic section of the male connector when connected to the female side is usually around 1cm.

O
owl707
Member
187
10-30-2022, 02:17 AM
#5
from top of the connector to top of the cable is about 1/4. if i remember right there was a trick to make your own 90. if each wire is signal not connected to each other i think you can bend it more. 2 wires needs to be longer then the other 2 to make the bend tighter. but 22mm is alot of space... Edited March 7, 2025 by thrasher_565
O
owl707
10-30-2022, 02:17 AM #5

from top of the connector to top of the cable is about 1/4. if i remember right there was a trick to make your own 90. if each wire is signal not connected to each other i think you can bend it more. 2 wires needs to be longer then the other 2 to make the bend tighter. but 22mm is alot of space... Edited March 7, 2025 by thrasher_565