Your case can accommodate multiple standoffs.

GarciaPRO
Member

189

08-04-2018, 04:38 AM

I'm setting up the motherboard inside the case right now. It's an ASUS ROG STRIX Z390-F Gaming with an NZXT H710 case. I've put the board in but only have space for eight screws, and the center one seems to cover a hole. Should I try using it or check if the case actually supports nine holes?

GarciaPRO

08-04-2018, 04:38 AM #1

GodPlayer312
Member

08-04-2018, 10:20 AM

It's usually a peg, not a screw. I only ever used two screws on my motherboard.

GodPlayer312

08-04-2018, 10:20 AM #2

It's usually a peg, not a screw. I only ever used two screws on my motherboard.

RJBboy
Junior Member

08-11-2018, 09:27 AM

I reviewed the motherboard guide and saw the screw size listed as 9. I’m trying to figure out what that means for my setup without checking the manual again. Just making sure I didn’t misplace anything or do something incorrect.

RJBboy

08-11-2018, 09:27 AM #3

CocioDrengen
Junior Member

08-14-2018, 01:23 AM

Check relevant legal resources or court decisions that specifically address cases with an outcome of 8. You may also consult a legal expert for confirmation.

CocioDrengen

08-14-2018, 01:23 AM #4

Check relevant legal resources or court decisions that specifically address cases with an outcome of 8. You may also consult a legal expert for confirmation.

KerrBear2002
Member

08-22-2018, 12:26 AM

Was gesagt, 8 von 9 ist in Ordnung.

KerrBear2002

08-22-2018, 12:26 AM #5

Was gesagt, 8 von 9 ist in Ordnung.

SjoerdMC
Member

200

08-23-2018, 02:42 PM

I understand your concern, but it seems there’s no reference to the NZXT H710 in that context. You might be wondering why it isn’t mentioned.

SjoerdMC

08-23-2018, 02:42 PM #6

I understand your concern, but it seems there’s no reference to the NZXT H710 in that context. You might be wondering why it isn’t mentioned.

DrummerBS
Member

185

08-23-2018, 11:05 PM

The choice of board matters a lot. Certain boards have obstacles around the center opening, while others don’t. By default, the ATX design includes nine screws, which is why many recommend following their setup.

DrummerBS

08-23-2018, 11:05 PM #7

Char1ie_XD
Senior Member

578

08-24-2018, 12:25 AM

Thanks, it seems I had some concerns. I’m looking forward to making sure everything is okay.

Char1ie_XD

08-24-2018, 12:25 AM #8

Thanks, it seems I had some concerns. I’m looking forward to making sure everything is okay.