You should position your APs in areas with good signal coverage and minimal interference.
You should position your APs in areas with good signal coverage and minimal interference.
The new space is approximately 2245 square feet. Most systems are already installed. The interior surfaces will consist of wood and drywall. You're considering placing the entryways in specific spots, aiming for the U6 Lite unless you find a superior choice.
You probably need just two APs to review the floor plan. In my view, one could be in the den on the main floor by the garage wall, and another in the loft on the second floor. This setup would cover everything thoroughly.
WAPs need to be positioned high and centrally. The calculations are like those for a radioactive source, aiming for the fewest blockages near the device.
The only detail about the Den is the plumbing and water area above it and its impact on signal strength to the second bedroom. It could be beneficial to relocate it to the garage for that reason, though it depends. @NightlyGamer If you intend to add smart devices in the garage, a placement there might make sense, especially if combined with a loft on the second floor, as a minor adjustment to @Skiiwee29's idea.
I understand, just reviewing the diagram. Results vary when working in person. During installs with Wi-Fi, I always assess requirements and perform a walkthrough checking the router’s coverage and RSI values to ensure proper signal strength. Last week I installed for a business and found it needed four extra mesh APs on top of the main router setup.
The majority of the plumbing is located in the ceiling and walls nearest the laundry room.
I first considered the corridor connecting the main entrance and the large room. The upstairs would be in the hallway linking the master suite and the second bedroom.
They shouldn't be placed one on top of the other in that way, as it would reduce their usefulness. If there are three levels, putting them on the first and third floors works better than stacking on the second story. Positioning them at opposite ends provides optimal coverage. They should reach through the spaces between to cover directly above and below without gaps or dead spots.