XMP and DOCP settings on RAM can trigger crashes in certain games.
XMP and DOCP settings on RAM can trigger crashes in certain games.
In short, one of the fortunate individuals managed to purchase a retail-priced RTX 3080 and Ryzen 9 5950X. They installed 64 GB of Corsair Vengeance 4 x 16 GB DDR4-3200 CL16 RAM and adjusted the XMP profile on their Asus motherboard to 3200 MHz. After changing it to Auto mode, crashes with certain games stopped occurring. However, using Auto still runs RAM at 2133 MHz. They experimented with different frequencies and found that setting the target to 3133 MHz worked well, though they haven’t tested it extensively yet. The remaining settings stayed at what XMP suggested. They wish to return RAM to 3200 MHz but worry about stability. Any guidance would be appreciated. Thanks!
Need full specs here ... (read the following). In the meanwhile update your motherboard BIOS to the latest.
Thanks for sharing the details. The BIOS is set to version 2311, and all drivers are current. The RAM runs at 3133 MHz, which seems stable, but the 3200 MHz spec is causing crashes. You might want to check BIOS settings for adjustments to stabilize it at 3200 MHz.
XMP is considered an overclock. Successfully running the RAM at those speeds relies on your motherboard and processor memory controller. Your parts list shows you're using 4x16GB sticks, filling all slots. This setup may not be ideal for high-frequency performance with tight timings—dense RAM and full slots aren't optimal. To restore 3200MHz, consider adjusting timings or increasing voltage to 1.4V or 1.45V, maybe both. Be cautious though; excessive timing changes can reduce stability. A safer approach might be to run at 3133MHz with the existing settings.
I chose this setup because the RAM cost was just right. My main use is for work, so a lot of memory was important from the start. I planned to use around 32GB during the day and wanted to avoid problems later, so I bought 64GB initially. I’m thinking about increasing the voltage—currently it’s 1.35, so I’ll try 1.4, 1.45 and see if it reaches 3200Mhz. If that doesn’t stabilize at 3200, I might settle for 3133 instead. Could there be a better way to test it without playing games? I really need a solid confirmation. Thanks again for your support!
There are options available. You might run a few memtest sessions or use the built-in stress test in Aida64 after overclocking. It’s useful because it offers flexibility to focus only on memory testing. After about 3 to 4 hours, you should get a clear idea of stability. Another choice is the Intel Burn Test, which quickly identifies memory issues.
What’s the issue then? Are you sure you can spot the difference for "3200"? Also, note that some boards behave oddly with numbers. Running at 133 stable is acceptable, and there’s no real reason or chance to push it to 000 unless it wasn’t built for that.
You bought 3200 RAM, not 3133, and your other parts are high-end. The phrase refers to the system not being built for that exact configuration.