x470 taichi paired with HX432C16PB3K2/16 fails to connect xmp
x470 taichi paired with HX432C16PB3K2/16 fails to connect xmp
Hey, I see the issue. The XMP profile isn't applying even though the RAM is listed in the ASRock QVL motherboard. Have you tried adjusting the XMP settings to match your actual RAM speed? Also, double-check if the RAM is properly seated and recognized by the system. Let me know what you try next!
If it's listed on a QVL and isn't functioning, you may return it. (Board or Ram, not sure which one)
Sure, let's make that clear. Please increase the font size for readability.
Also, ensure the RAM is placed in slots 2 and 4. Confirm the configuration: SOC set to 1.1, DRAM at 1.35. Attempt 2933 with XMP/DOECD enabled. After that, run Memtest86 or OOCT to verify stability. If successful, proceed with 3200 using the same settings and run Memtest or OCCT for further assurance.
Install the two RAM modules in slots 2 and 4 if needed. Turn on XMP support; if issues persist, lower the frequency to 3000/2933MHz and adjust the voltage slightly to around 1.4V, also tweak the SoC settings. If problems continue, this is the recommended ASRock memory QVL.
Hey, after restarting the PC again, the error 7b appears and it blocks further progress. I’ve removed the motherboard from the tower, switched to a different power supply, cleared all cables, checked RAM and other components—but nothing changed. The sequence keeps showing 54, then 7a, then 7b and it stays stuck in that state. Could you help figure out what might be causing this? Thanks!