F5F Stay Refreshed Software Operating Systems windows XP

windows XP

windows XP

N
noodle54
Member
69
06-26-2020, 03:22 AM
#1
You might need to adjust your BIOS settings to allow legacy boot options. This could help the Windows XP USB boot correctly even if you're using a newer motherboard like the Z97 SOC from Gigabyte. Make sure the boot menu includes an option for older operating systems and verify that the USB drive is properly recognized.
N
noodle54
06-26-2020, 03:22 AM #1

You might need to adjust your BIOS settings to allow legacy boot options. This could help the Windows XP USB boot correctly even if you're using a newer motherboard like the Z97 SOC from Gigabyte. Make sure the boot menu includes an option for older operating systems and verify that the USB drive is properly recognized.

S
SnifePvP
Posting Freak
872
06-26-2020, 09:42 AM
#2
No, I'm not using a recent computer.
S
SnifePvP
06-26-2020, 09:42 AM #2

No, I'm not using a recent computer.

F
fiuffy7
Junior Member
13
06-27-2020, 12:28 AM
#3
The device is connected to the network through a separate partition.
F
fiuffy7
06-27-2020, 12:28 AM #3

The device is connected to the network through a separate partition.

A
Aleshop777
Member
153
06-27-2020, 04:34 AM
#4
Only systems running Windows 8 or newer support UEFI exclusively in the BIOS.
A
Aleshop777
06-27-2020, 04:34 AM #4

Only systems running Windows 8 or newer support UEFI exclusively in the BIOS.

L
LubyDaOreo
Member
120
07-02-2020, 01:46 PM
#5
Check if the USB drive is set to NFTS or fat32 format. If you've tested both, consider using another drive. Some USB sticks may have issues starting an operating system.
L
LubyDaOreo
07-02-2020, 01:46 PM #5

Check if the USB drive is set to NFTS or fat32 format. If you've tested both, consider using another drive. Some USB sticks may have issues starting an operating system.

I
IMayBeDead
Senior Member
696
07-04-2020, 05:03 AM
#6
Rufus prepares the USB drive for booting in either UEFI or Legacy mode. Due to limited Windows XP compatibility with new chipsets, it recommends using IDE mode instead of AHCI. If EFI startup fails, switch to LEGACY mode.
I
IMayBeDead
07-04-2020, 05:03 AM #6

Rufus prepares the USB drive for booting in either UEFI or Legacy mode. Due to limited Windows XP compatibility with new chipsets, it recommends using IDE mode instead of AHCI. If EFI startup fails, switch to LEGACY mode.

S
slimemaster22
Member
55
07-04-2020, 09:34 AM
#7
I've used NTFS and Fat32 before, but the same USB drive worked when I installed Windows 8.1 earlier. I'm checking another guide to see if it helps, and I'll return soon to check again. There are two BIOS settings on my board—UEFI and Legacy—and I already have Windows 7 on a different partition, so it seems to function properly. Others have used XP with the same setup, which suggests it should work too.
S
slimemaster22
07-04-2020, 09:34 AM #7

I've used NTFS and Fat32 before, but the same USB drive worked when I installed Windows 8.1 earlier. I'm checking another guide to see if it helps, and I'll return soon to check again. There are two BIOS settings on my board—UEFI and Legacy—and I already have Windows 7 on a different partition, so it seems to function properly. Others have used XP with the same setup, which suggests it should work too.

S
Sebastiansbk
Member
152
07-04-2020, 03:59 PM
#8
You shouldn't install XP on a 2014 chipset. The issue is your motherboard uses UEFI, and 32-bit XP isn't compatible. You might be able to run it with Legacy Boot or similar configurations, but XP is outdated and unsupported. For older benchmarks, performance likely won't improve much. Unless you're using something from 2007 when Vista was released and most systems had Core 2 Duos, consider upgrading to Windows 10. You can still use Windows 7 if needed, it's supported through 2020, or try Windows 8.1 if you prefer it over 10.
S
Sebastiansbk
07-04-2020, 03:59 PM #8

You shouldn't install XP on a 2014 chipset. The issue is your motherboard uses UEFI, and 32-bit XP isn't compatible. You might be able to run it with Legacy Boot or similar configurations, but XP is outdated and unsupported. For older benchmarks, performance likely won't improve much. Unless you're using something from 2007 when Vista was released and most systems had Core 2 Duos, consider upgrading to Windows 10. You can still use Windows 7 if needed, it's supported through 2020, or try Windows 8.1 if you prefer it over 10.

C
ciemnamasa
Junior Member
3
07-09-2020, 08:39 AM
#9
The standards perform optimally on XP, with every world record achieved on HWBOT using XP. This isn't my primary operating system; it's reserved for these older legacy benchmarks. Here are some links:
- http://hwbot.org/submission/2784525_danc...0sec_765ms
- http://hwbot.org/submission/2505538_chi_..._5sec_78ms
- http://hwbot.org/submission/2370862_spla...5sec_125ms
C
ciemnamasa
07-09-2020, 08:39 AM #9

The standards perform optimally on XP, with every world record achieved on HWBOT using XP. This isn't my primary operating system; it's reserved for these older legacy benchmarks. Here are some links:
- http://hwbot.org/submission/2784525_danc...0sec_765ms
- http://hwbot.org/submission/2505538_chi_..._5sec_78ms
- http://hwbot.org/submission/2370862_spla...5sec_125ms

K
Killa_Dx
Senior Member
645
07-09-2020, 10:39 AM
#10
Activate CSM/Legacy Boot and set up installation via CD, avoiding USB usage.
K
Killa_Dx
07-09-2020, 10:39 AM #10

Activate CSM/Legacy Boot and set up installation via CD, avoiding USB usage.