Windows 10 UnUpdatable issue Find solutions for unresponsive updates on your system.
Windows 10 UnUpdatable issue Find solutions for unresponsive updates on your system.
Hello guys, Do you know what's with my mb/ahci and ide drivers? 1. I installed Windows 10 at AHCI, even IDE with no problems, except BSoD with no fail code 2. After that I wanted to update Win to latest build, so I started installation etc. etc. 3. At 89 % the update assistant normally asked me for restart 4. After restart the Windows started updates. It was probably at 29 % and suddenly my PC restarted 5. Boot to OS with drive repair etc. And BSoD 0xc000000f. 6. When it boots Win (without updates), Win are lagging and in task manager I have 100% drive use. WTF? Sometimes it boots to OS normally, but without the update. Sometimes it boots without that 4. point. But in most of it I see that code 0xc000000f. Now that drive is fully clean with no OS. So my question is: How can I install Win 10 and its latest update without any problems? Thank you for your advance.
This process aims to resolve boot problems by using specific settings. Avoid selecting IDE in the BIOS; instead, enable AHCI. After configuring AHCI in BIOS, enter safe mode first, then proceed normally. In Windows, open Command Prompt as Administrator and run these commands: bcdedit /set {current} safeboot minimal Restart, go to BIOS setup (key differs), switch SATA mode to AHCI from IDE or RAID. Apply changes, exit setup and Windows will boot safely. Repeat the safe mode steps in Command Prompt and complete the reboot with AHCI drivers active.