Wi-Fi strength decreases during data transfers.
Wi-Fi strength decreases during data transfers.
I've observed an issue with my ASUS B550-E motherboard where the onboard card's signal drops from 90% to 70% during downloads. The problem seems consistent across different cards, except for the TP-Link PCIe Wi-Fi model which maintains a stable signal. Could there be a compatibility or driver issue with the Intel AX200?
Additional details are required: Is the decrease in signal strength affecting your internet speed limits? Have you updated the Intel AX200 drivers? Are all connectors and antennas on the AX200 properly secured? Are there any blockages near the adapter’s antennae? If present, relocate them or move the device away from the floor or wall. Devices like cordless phones, Bluetooth gadgets, refrigerators, freezers, etc., can interfere with wireless signals if positioned between the source and your device. How close is the PC to the wireless router/AP? Are there any walls or floors between them? Materials such as concrete, metal, and multiple walls greatly weaken the signal. What is the model of your wireless router/AP? Does it support WiFi 6? What settings are configured on it? Is it connected to the 2.4GHz or 5GHz frequency band? How congested are the 2.4GHz and 5GHz bands in your area? Consider using a wireless analyzer, for example WiFiman for mobile, to perform a survey.
While performing a speed test and downloading, the connection drops from 350 Mbps to 50 Mbps. 2. Yes 3. Yes 4. No 5. Upstairs one flight, router downstairs 6. Virgin Media Hub 5/WiFi 6 Router 7. I didn't realize this issue was new. I suspect it might be related to the antenna installation but I'm unsure. Recently, while setting up a third-party antenna, one of the RP SMA female connectors came loose due to tension during mounting. Could this be affecting the signal? I managed to secure it with a tiny tweezer, though the connector appears slightly bent on one side. The antenna fits snugly but doesn't seem to thread properly.
Most home wireless routers and gateways feature omnidirectional antennas that perform better when aligned with clients in the same horizontal plane. Vertical signal spread remains a difficulty. Wireless configuration settings matter—determine which band the computer is connected to. Run the analysis; these connectors can be adjusted from the reverse side of the I/O panel if accessible. For the pin, simply straighten it. Remove the connector and reattach it carefully, making sure it doesn’t cross-thread. Perhaps this is the issue at hand. How does using the original antennae affect performance?
I can't capture a picture directly. However, you can describe the connector in detail so someone can take a clear photo. Also, verify that the pin is making solid contact and that the VRM heatsink is separate from the I/O shroud. Look for any detachable clips on the shroud.