What to Consider When Purchasing Water Cooling Components?
What to Consider When Purchasing Water Cooling Components?
So for my next build, I'm switching from AIOs on my CPU and GPU to custom loops. I understand the general guidelines for what to purchase, like Pump Reservoir Tubing ETC. But I need more specific information. For example, what tubing dimensions should I buy? Which fittings are appropriate? How do I determine the correct sizes for the fittings? And how do I properly attach the tubing to the fittings? If there are any water cooling experts out there, I'd really appreciate advice on these topics. Thanks!
Both tubing and fitting size are determined by ID and OD (inside and outside diameters). You'll require two fittings for each part (inlet and outlet). Although the adhesive is a bit outdated, the same principles still hold. Ensure that the fitting and tubing match in both inner and outer diameters?
Both tubing and fitting dimensions are based on ID and OD (inside and outside diameters). You'll require two fittings for each part (inlet and outlet). Although the adhesive is a bit outdated, the same principles still hold. A few of the examples used are quite old, but the ideas remain unchanged.
Both tubing and fitting size are determined by ID and OD (inside and outside diameters). You will need two fittings for each part (inlet and outlet). Although the adhesive is a bit outdated, the same principles still apply. Some components used as examples are quite old, but the ideas remain unchanged.
In my upcoming build, I’m planning to replace AIOs on my CPU and GPU with custom loops. I understand the essential components to purchase, such as Pump Reservoir Tubing ETC. However, I need more specific guidance. For example, what tubing dimensions should I buy? Which fittings are appropriate? How do I determine the correct sizes for the fittings? What steps are involved in mounting the tubing onto the fittings? If there’s any water-cooling expert out there, I’d really appreciate their advice on these matters. Thanks!
lancer420 :
rubix_1011 :
Both tubing and fitting size depend on ID and OD (inside and outside diameter). You’ll require two fittings for each part (inlet and outlet). Even though the sticky is somewhat outdated, the same principles still hold. Just confirm that the fitting and tubing share identical inner and outer diameters?
Yes, but keep in mind that flexible tubing and hardline tubing must use different fittings—they each have specific ones suited to their respective tubing types. This depends on the tubing type paired with the fittings, ensuring compatibility with any watercooling component (G1/4 thread, distinct from fitting ID or OD).
And definitely do your own research; explore available options and verify everything makes sense before purchasing. Be sure you’re getting accurate information from reliable sources, not just someone on a forum.
Both tubing and fitting size are determined by ID and OD (inside and outside diameters). You’ll need two fittings for each part (inlet and outlet). Even though the adhesive is a bit outdated, the same rules still apply. Some examples used here are quite old, but the ideas are still valid. Make sure the fitting and tubing match in both inner and outer diameters?