Using Router as a Wi-Fi booster issue The router isn't functioning properly, causing weak or no signal.
Using Router as a Wi-Fi booster issue The router isn't functioning properly, causing weak or no signal.
To achieve your goal, you’ll need to set up the old router properly as a Wi-Fi extender. Connect it via its LAN port using Ethernet to another router. Make sure the configuration settings allow it to act as an extension point for your main network. Regarding the IP issue, try changing the static IP manually or contacting your ISP to resolve the WAN Area restriction. For monitoring, use tools like Wireshark to inspect traffic and see what’s happening with those IP addresses.
I believe it hinges on the router model, but you should connect your "old router" as the "new range extender" directly to your PC. Make sure your PC isn't connected to anything else or using Wi-Fi. This ensures you reach the correct device when accessing 192.168.1.1. You might adjust its IP address in the web interface, but without knowing your exact setup and interface, I can't guide you precisely. Also, regarding short Ethernet connections, it’s unclear what you aim to achieve. Unless the extender supports firmware for bridging Wi-Fi to Ethernet, it won’t function properly as a bridge unless you use the router’s DD WRT firmware for more advanced configurations. If you intend to run a direct wire from the router to your PC, consider using the original router instead of the new extender in that setup.
The WebUI refers to the previous version of Netgear's web interface, similar to the one shown in the image. This setup was chosen for configuration purposes. Running a short Ethernet cable is necessary since the router is too far away; it's located in my mother's room, and I need to connect multiple devices to the main router for stable internet access.
If you could connect one cable from the main router to your new device, it would work as a wireless access point and a switch. Otherwise, it’s unclear whether you can set up your current router to get a Wi-Fi signal and link it to its Ethernet ports. You’d need to research your specific router online for guidance.