Use the motherboard Ethernet connection as the device output.
Use the motherboard Ethernet connection as the device output.
I previously shared information about setting up a modded Minecraft server, but I noticed my motherboard doesn’t support wireless internet. I do have a PCIe Wi-Fi card, though my board lacks a PCIe slot. My plan is to run an Ethernet cable from my home all the way to my room, but it’s too short for comfort. It only reaches just enough to fit through my doorframe, and if I use it, the server would need to be placed right next to it. I’d prefer it under a table or in a corner instead. Since I have a Wi-Fi card on my main PC, I thought I could use my motherboard port as an output to connect my Ethernet from the main PC to the server. I know it’s possible, but I saw that a crossover LAN cable is required and regular ones won’t work. Is that correct? Do I need a special cable for this setup? What’s essential for it to function? If that doesn’t work, I suppose the server would have to be right outside my door.
It functions adequately, though it doesn't stand out as exceptional.
Obtain the appropriate length wire and attach it to your switch or modem.
Not exactly what I was looking for, but those might be a possibility. I just need to purchase one, though I don’t want to. Since I already have Wi-Fi on my main PC, I thought I could share that connection through its Ethernet port to the server PC. I discovered an old USB Wi-Fi adapter in my shelf, but it’s bent and I’m unsure if it functions properly. Probably best to test everything first.
A moderately modern computer, likely built around 2015, should work without a crossover cable. You might face Wi-Fi to Ethernet bridging problems, requiring a NAT setup which could cause some issues.
I’d probably purchase a fresh Ethernet cable, though cat5 is quite pricey in Sweden. A 20-meter cat5 cable typically costs between 35 to 40 USD (for decent performance). There are more affordable options available, but they’re not reliable. Spending that much on a server that might only be online briefly isn’t something I’d consider.
Many modern devices include a capability called Auto-MDIX. When needed, the system will automatically adjust the settings for you. You can connect using a standard Ethernet cable. In the Network Connections menu, navigate to the properties and sharing section of your wireless NIC, then share its network connection through either of your Ethernet ports to grant clients internet access. However, this method functions as a partial NAT, so certain services may not operate properly when you attempt to host a server for the wider internet. In such cases, a direct connection to the router is recommended.